Is Modification Needed To Swap From An 8 Amp To 10 Amp Draw RV Water Pump
Updated 02/27/2023 | Published 02/25/2023
Products Featured in This Question
Question:
any modification on a pump at 10 amps from original 8 amps....from a shurflo 2088-422-144 to a hrydro max p25201.
asked by: Jacques L
Expert Reply:
No, there really shouldn't be any changes that you'll have to make switching from an 8 amp draw ShurFlo to the 10 amp draw HydroMax RV Fresh Water Pump # P25201. I would just check the fuse rating to ensure it's rated for 10 amps. Your pump is either ran to the battery directly with an inline fuse holder # C58470-1 or ran to the DC distribution panel with a fuse in the panel. Other than that you'll be good to go swapping them out.
Product Page this Question was Asked From
Flow Max RV Fresh Water Pump - 12 Volt - 3.0 Gallons Per Minute - 50 PSI
- RV Water Pump
- Diaphragm Pump
- 3.3 gpm
- 50 psi
- 140F
- 60C
- 12V
- Lippert
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement For Artis Water Pump PDS1RV25
- Q&A: Replacement for a Artis PDS1-130-1240E Pump
- Q&A: Replacement Water Pump Recommendation For A Shurflo 2088=-422-175
- Q&A: Replacement for Shurflo 2088-422-174 Fresh Water Pump
- Q&A: Fresh Water Pump to Replace Shurflo 2088-422-144
- Q&A: Recommended Replacement For A SHURflo 2088-403-444 Water Pump
- Q&A: Replacement For A Flow Max DS-01230-M2 12v RV Fresh Water Pump
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: How Much Solar Power Do I Need For My RV?
- Article: How Does an RV Water Pump Work?
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited