Snow Socks that Fit Tire Size 225/60-18

Question

Question:

Will they fit an outback tire 225 60 18

asked by: John

0

Expert Reply:

We have a set of Snow Socks that fit your tire size of 225/60-18 with the part # TCH70.

expert reply by: Jameson C

0

Answer 1

The correct ISSE Hybrid Snow Socks for a 2020 Subaru Forester with 225/55-18 tires is part #TCH70. The owner's manual as you stated recommends against using tire chains but does suggest alternative options which is where the snow socks come into…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 4

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 5

Hey Morgan, the best hitch for what you are looking for would be the Draw Tite part #DT73RR which has the easiest install and the highest tongue weight rating. The hitch does fit right up under the rear bumper which will slightly reduce ground…

view full answer...

Answer 6

Hey Nick congrats on the new car! The bottom portion of the receiver for the Curt item #C69VV sits 11-3/4" above the ground when installed on your 2025 Subaru Outback Premium. If you're worried about ground clearance, I recommend installing…

view full answer...

Answer 7

Hi Jessey! We have everything you need for your 2024 Subaru Outback. To start, I recommend the Curt Trailer Hitch Receiver - Custom Fit - Class III - 2" #C67JR. This is a little bit of work to get installed, but it is going to be the best…

view full answer...

Answer 8

Hey Poches, happy to help! The torque spec for the Draw-Tite Max-Frame Hitch #DT73RR is 50 lb-ft for all the bolts that the hitch comes with. You can also find this listed in step 8 of the installation instructions if you want to double-check while…

view full answer...

Answer 9

Hey Lawrence thanks for the information! I wasn't able to find any good pictures of the inside of your Axle Tecknology BD2-655 drums. What you'll need to do is pull one of the hubs off and look at the inside. If they're smooth like the…

view full answer...

Answer 10

Hey Andy, the bolts that come with the Demco Spare Tire Mount for up to 4" Trailer Tongue #DM15851-52 that you referenced are right at 4 inches long 3/8 inch diameter and are a fine thread. Did you lose yours?

view full answer...

Answer 11

The Curt Class III hitch part #C67JR and EcoHitch - 2020 Subaru Outback Wagon part #EH34FR are both very similar as far as looks go on the 2020 Subaru Outback Wagon. They are both hidden cross tube designs so the only part of the hitch that is…

view full answer...

Answer 12

Hello Ian, thanks for reaching out. Yes, the Draw-Tite #DT73RR is the correct fit for the 2025 Subaru Outback Wilderness. The picture below shows an example of what this hitch will look like installed on the Wilderness model. Feel free to reach out…

view full answer...

Snow Socks that Fit Tire Size 225/60-18

Product Page this Question was Asked From

Continue Researching