Can I Get a Replacement Leg for the Lippert High-Speed Power Stabilizer Jack
Updated 07/25/2022 | Published 07/22/2022
Question:
I have a 2021 Crossroads Cruiser Aire 30RlS. One of my stabilizing jacks is bent. Can I remove one of the legs to have it repaired? If so how? The end with the two yellow bars is obvious but I don’t know how to remove the other side of it. Thanks.
asked by: Craig U
Expert Reply:
If the actual leg of the stabilizer jack, like the Lippert High-Speed Power Stabilizer Jack # LC298707, is bent then you'll unfortunately have to replace the entire assembly. Lippert has a few replacement parts for this jack but I think the mentality behind not having a replacement for the leg is that if there was an impact powerful enough to bend one of the legs then the frame of the unit is likely messed up as well so you'll want to replace the whole thing from the safety viewpoint.
Attached is a review video for you to check out.
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: above the bed gooseneck hitch
- Search Results: pd55k003
- Shop: Reese Above-Bed Gooseneck Trailer Hitch for Max Duty Underbed Mounting System - 14,000 lbs
- Shop: Curt Spyder Gooseneck Trailer Hitch for Fifth Wheel Rails, 25,000 lbs GTW
- Shop: Reese Elite Series Above-Bed Gooseneck Trailer Hitch - 25,000 lbs
- Shop: Gooseneck Hitch
- Shop: White Grease Hitch Ball Lube
- Shop: Go Power Inverter Fuse with Block - Class T - 200 Amp
- Shop: Go Power Solar Elite Charging System - 400 Watt Solar Panels - 2,000 Watt Inverter Charger
- Shop: Progressive Dynamics 5000 Series AC/DC Distribution Panel - 30 Amp
- Q&A: Replacement Jack or Support Arms for Lippert PSx1 Stabilizer
- Search Results: lippert stabilizer parts