Tip for Removing Difficult Pin that Holds Gooseneck Hitch Ball
Published 06/14/2022 >
Question:
I have used WD40 and have gotten the pin to move but it will not pull all the way out. I have tried everything. The pin moves great up until a point and then does not move anymore. Any help would be great.
asked by: Chris
0
Expert Reply:
Have you tried putting some of the pin weight of the trailer on the hitch ball when you try to remove the pin that holds the ball? Sometimes doing that allows it to free up. You can also try the opposite direction where you use the gooseneck coupler to pull up on the ball with the trailer jacks.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Hitch Ball for B&W Turnoverball Underbed Gooseneck Hitches - 2-5/16"
- Trailer Hitch Ball
- Gooseneck Hitch Ball
- Pop-In Ball
- Coated Steel
- 2-5/16 Inch Diameter Ball
- B and W
more information >
Continue Researching
- Q&A: Repair Kit for Ram Channel Tongue Coupler
- Q&A: Replacement Dual Track Repair Kits for Lippert RV Schwintek In-Wall Slide-Outs
- Q&A: Recommended Replacement For A Dexter A-60 Brake Actuator With A Broken Safety Cable
- Q&A: How to Replace Interior Ram Jack Rod and Nut # TJD-12000-RODNUT on 12000 Series Jacks
- Q&A: Dimensions Of B&W Gooseneck Turnover Ball
- Q&A: Potential Causes for Uneven Wear on Trailer Tires
- Q&A: Does Speed Affect Tire Wear on a Trailer Tire
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: 5th Wheel Hitch Installation | The Ultimate DIY Guide
- Article: How to Measure for Trailer Hitch Drop
- Article: Gooseneck Trailer Hitch Information and Review
- Article: Gooseneck to 5th Wheel Adapters
- Article: 5th Wheel to Gooseneck Adapters

