Replacement Installation Hardware for Draw Tite Trailer Hitch # 75528
Updated 05/26/2020 | Published 10/09/2013
Products Featured in This Question
Question:
I guess i was trying for the dummy of the year award and managed to strip the handle nuts during install on the Draw Tite 75228 that I purchased from you about a month ago. Do you have a fastener kit part number 75528F for that hitch available and ready to ship.
asked by: Dickie A
0
Expert Reply:
Yes, you can get replacement hardware kit # RHK which will replace all the hardware for the hitch. Just enter the hitch number where indicated on the page and our team of hardware ninjas will compile the proper kit.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 750 lbs TW
- 5000 lbs GTW
- 7500 lbs WD GTW
- 2 Inch Hitch
- 750 lbs WD TW
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Replacement Hardware Kit for Trailer Hitches
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Determining Trailer Tongue Weight
- Article: Rooftop Cargo Carriers
- Q&A: Comparing Curt and Draw-Tite Trailer Hitch Receivers for 2017 Chevrolet Traverse
- Q&A: Trailer Hitch and Wiring for 2011 Chevy Traverse LT
- Q&A: Where Is The Trailer Tow Wiring Located On 2017 Buick Enclave
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Q&A: Best Hidden Hitch And Wiring For 2014 GMC Acadia
- Q&A: Wiring Harness for 2016 Buick Enclave Without Tow Package
- Q&A: Easy to Install Trailer Wiring Kit for 2015 Buick Enclave without Trailer Wiring
- Article: Which Sway Control Hitch is Right For Your Trailer?
Roger
5/23/2020
I have a 2012 GMC Acadia with towing package. I recently purchased a camper with gvw about 4100lbs. It pulls the camper great. However a mechanic noticed my 2 center bolts were missing on the hitch and is now bent down. I am wondering how good those welded nuts are and wondering what I can do now. I'm not sure if this happened since I purchased the vehicle or not. Is it possible to have a welded nut and the nut handle both on for greater safety. If hitch is bent I suppose I would have to purchase a new hitch. Wondering what I should do going forward. Also do you know what type of hitch was oem for 2012 GMC Acadia. Looks very similar to the Draw Tight hitch. Can a bent hitch be corrected and or do you think this could have bent the frame.