Does Jounce Bumper Get Removed when Installing AirLift Suspension Enhancement on a 2005 Chevy Malibu
Updated 08/28/2013 | Published 08/24/2013 >
Question:
I currently have the AirLift 1000 part AL60776 and would like to install on a 2005 Chevy Malibu. The installation instructions do not include any information on whether the jounce bumper needs to be removed or if it can remain in place. I am wondering if I can leave it in place, or if it needs to go? It appears that the bag will fit between the jounce bumper and frame when installed per the manufacturers directions, but I am wondering if it will function properly if the jounce bumper is not removed. Thank you for your assistance.
asked by: Shawn
Expert Reply:
The installation instructions for the AirLift kit # AL60776 can be a little confusing. But after reviewing them on a 2005 Chevy Malibu you will not do anything with the jounce bumper. Just leave it in place. Do not remove the bumper because that can cause fit and performance issues.
Product Page this Question was Asked From
Air Lift 1000 Air Helper Springs for Coil Springs - Rear
- Vehicle Suspension
- Towing/Load Leveling
- Air Springs
- Suspension Only
- Light Duty
- Rear Axle Suspension Enhancement
- Air Lift
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Is Drilling Required for Installation of Coil-Rite Air Helper Springs on a 2009 Nissan Altima
- Q&A: Recommended Flat Tow Setup For 2011 Chevrolet HHR
- Q&A: Will Air Lift 1000 Air Helper Springs Fit 2004 Chevy Malibu

