What is the Metal Thickness of etrailer CA-5100-Z Weld-On 2-Inch A-Frame Trailer Coupler
Updated 07/16/2021 | Published 07/14/2021
Question:
Where is this item made? What is the metal thickness gauge?
asked by: Jack
0
Expert Reply:
The etrailer brand # CA-5100-Z is manufactured in China. It's constructed of 1/8 inch thick stamped zinc plated steel, which works out to be 11 gauge. For a US made 2 inch weld-on A-Frame coupler of the same thickness, I'd recommend the Dutton-Lainson # DL14008 which is constructed of 11 gauge stamped steel that features tough enamel finish. The coupler has a 5000 lb capacity, like the # CA-5100-Z coupler you'd looked at.
expert reply by:
Mike L
0
Product Page this Question was Asked From
A-Frame Trailer Coupler - Trigger Latch - Zinc - 2" Ball - Weld On - 5,000 lbs
- A-Frame Trailer Coupler
- Standard Coupler
- 50-Degree Frame
- Weld-On
- 5000 lbs GTW
- 2 Inch Ball Coupler
- Trigger Latch
- 2-1/4 Inch Hole
- Marine Grade
- etrailer
more information >
Continue Researching
- Q&A: What do I Need to Go from Electric Brakes from Hydraulic with Surge Brake Actuator?
- Q&A: Replacement Disc Brake Kit for Mastercraft Trailer
- Q&A: Replacing Older Tie Down Engineering 46210 and 46845 Trailer Hubs
- Q&A: Replacement Leaf Spring For Dexter Leaf Spring # 072-099-01
- Q&A: Replacement for Shelby 5101 Coupler
- Q&A: Is There a Repair Kit for Atwood Coupler?
- Q&A: Hub and Drum Assembly with 8 on 6-1/2 Bolt Pattern for Dexter 10,000 Pound Trailer Axle
- Article: Trailer Wiring Diagrams
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: Trailer Lighting Requirements
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure a Trailer Axle