What Size Leaf Spring Bushing Is Required To Use 2 Slipper Spring Equalizer 13-118-03?
Updated 08/26/2024 | Published 06/14/2021 >
Products Featured in This Question
Question:
#13-118-03 Equalizer Do you know what bushing goes in the eye of the leaf springs that use this equalizer? Note: Axle is dual wheel
asked by: Joel M
0
Expert Reply:
The # 13-118-03 you were looking at is designed for 9000lb 2" wide slipper springs with that have a 5/8" Inside diameter bushing like the 6-Leaf Slipper Spring for 9,000-lb Trailer Axles - 30" Long # DX83QR.
As long as the bushing has an I.D. of 5/8" the spring will bolt up perfectly to the # 13-118-03.
expert reply by:
Samuel C
0
Product Page this Question was Asked From
Equalizer for 2" Wide Slipper Springs - 17-3/8" Long - 1" Center Hole
- Trailer Suspension Parts
- Standard Equalizer
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Slipper Springs - 2 Inch
- 17-3/8 Inch Long
- Tandem Axle
- Triple Axle
- Dexter
more information >
Continue Researching
- Q&A: Replacement Slipper Spring Equalizer for Kaufman Triple Axle Trailer
- Q&A: Can Breakaway System of Trailer be Used as Parking Brake
- Q&A: Replacement for a Dexter 072-032-00 Slipper Spring
- Q&A: How To Determine The Correct Leaf Springs For A Gooseneck Trailer
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: What Gauge Wire Should be Used to Wire Trailer Brakes
- Q&A: Replacement for UFP HD1377 Trailer Hub/Drum
- Q&A: Can I Get Replacement Keys For the InfiniteRule Lock Series?
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Measure a Trailer Axle
- Article: Trailer Wiring Diagrams
- Article: Double-Eye Trailer Suspension System Review
- Article: What Is A Leaf Spring? (Everything You Need to Know About Trailer Leaf Suspension)
- Article: Slipper Spring Trailer Suspension System Review


Richard
8/23/2024
I have a 2008 Newmar fifth wheel dual axles with dual wheels in your opinion Would it benefit me to put new leaf springs underneath it? I’m thinking this fifth wheel weighs about 17,600 empty GVW of 20,000 pounds it has been sitting on those springs for 16 years I’m thinking the springs had to weaken over that length of time in your opinion would it benefit me to put new ones under it? Seems to be riding fairly rough, especially on bridge expansion joints.