Turning Off Military Time On A Furrion DV3100

Updated 03/12/2024 | Published 06/04/2021

Question:

How do I change the clock setting from military time to a 12 hour clock?

asked by: Jeff S

Expert Reply:

To change the time from military to standard on your Furrion DV3100 you'll need to press and hold the "Zone 1" button until the display shows "Auto-RDS Off". From there you can use the remote to change to clock settings to the correct time.

expert reply by: Kevin C

Terry W.

3/9/2024

I tried the above and the message that came up was MCU v3.3. It’s still on military time. Ant other ideas

Kevin C.

3/12/2024

@TerryW I recommend removing the stereo from the wall and pulling the fuse in it to kill power and reset the unit. I'd wait about 15 minutes and then reinsert the fuse and try the steps listed above again. If it still refuses to change then I'd reach out to Furrion to see if they might have an alternative solution or could warranty out your stereo.

Terry W.

3/12/2024

@KevinC I did reach out to Furrion they said this It does appear that on page 9, the clock does need to be in the setup mode. I do recommend setting the area frequency to USA1/USA2 for the region, this is found on page 10. I hope that this helps! Please let us know if we can assist you further! Please kindly reply directly to this email ONLY. Replying directly to this email will ensure your reply is properly routed to your case history So I have two tricks to try. Thanks for your response

Terry W.

3/12/2024

@KevinC I got it to turn off, auto rds. On my unit it was the zone B button not Zone A. I don’t know if I’m an outlier or some models flipped buttons. I’m good though thanks for your help.