Does Rear Trim of 2014 BMW X1 Need to Get Removed to Install Hitch
Updated 05/27/2021 | Published 05/26/2021
Question:
The trim and brackets I think are not reinstalled when installing the hitch. Is it possible with the appropriate rivet gun to reinstall them, if for instance one wanted to remove the hitch at a later date and bring the car back to its original condition?
asked by: JSM
0
Expert Reply:
When installing the Curt hitch part # C13140 on your 2014 BMW X1 the lower fascia does need to be temporarily removed but does get put back on. You would not have to discard it altogether or leave it off like you mentioned.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 250 lbs TW
- 2500 lbs GTW
- 2 Inch Hitch
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: How To Install Trailer Wiring Harness on 2014 BMW X1
- Q&A: Replacement Anti-Rattle Bolt for a Yakima EXO SwingBase Swing Away
- Q&A: Kuat Vagabond X Roof Cargo Basket, Ski and Snowboard Carrier
- Q&A: How to Replace a Lance 6-Pin Plug w/ a Standard 7-Way Connector
- Q&A: Availability of Replacement Cover for Discontinued Atwood MPD 86065 Jack
- Q&A: Adding Anti-Sway Products to a 2022 Motorhome on a Ford F-600 Chassis
- Q&A: Will Buyers Products 42" x 13-1/2" Gooseneck Hitch Plate Fit 2016 Ford F-250 Super Duty
- Article: Adding Electric Over Hydraulic Disc Brakes
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)