Which Mounting Hardware for Pack 'em PK-6 Trimmer Rack
Updated 04/16/2021 | Published 04/15/2021
Question:
What bolt length is recommended for these? And should I get washers or lock washers?
asked by: Manny
0
Expert Reply:
The length of mounting hardware needed for the Pack 'Em # PK-6 trimmer rak will depend on how and to what you mount the racks. Using 3/8 inch grade 8 bolts, nuts and lock washers is what's recommended by the manufacturer.
I've linked to an installation video that you might find helpful.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Pack'Em Trimmer Rack for Utility Trailers
- Trimmer Racks
- Utility Trailer
- 3 Trimmers
- Pre-Drilled Holes
- Locks Included
- PackEm
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Availaiblity of White Half Moon Trailer Vent
- Q&A: Recommended Trailer Hitch for 2025 Hyundai Palisade
- Q&A: Comparing Uni-Servo and Free Backing Hydraulic Drum Trailer Brakes
- Q&A: Hopkins 7-Way Trailer Connector to Older Featherlite Wiring Recommendation
- Q&A: Idler Hub To Replace TDE 46245 Hub and Rotor On Boat Trailer
- Q&A: Will Pack'Em Rack for Open Utility Trailers Fit 2' high Sides on Trailer
- Q&A: Steering Stabilizer for 2025 Class C RV on Ford E-450 Chassis
- Article: How to Measure for Trailer Hitch Drop
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Trailer Maintenance Schedule
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure a Trailer Axle
- Article: How to Install E-Track in 3 Easy Steps