Should a Circuit Breaker Be Installed In-line with Tow Ready Battery Isolator Solenoid
Updated 12/01/2020 | Published 11/28/2020
Products Featured in This Question
Question:
For the tow ready isolator solenoid, should I put a 40am auto reset breaker on either side of the hot lead and the output to auxiliary?
asked by: Chad S
0
Expert Reply:
Yes. When installing the Tow Ready Battery Isolator Solenoid # PK5231201 we do recommend installing a 40 amp circuit breaker # 9510 in line to protect your system.
expert reply by:
Erik B
0
Product Page this Question was Asked From
Starter Solenoid - SPST - 12 Volt - 100 Amp - Continuous Duty - Grounded
- Accessories and Parts
- Battery
- Switches and Solenoids
- 100 Amp
- Pollak
more information >
Continue Researching
- Q&A: Replacement Option For Norcold N306.3 RV Fridge
- Q&A: How to Turn Off 12-V Power Feed to 7-Way Trailer Connector on Vehicle When Ignition is Shut Off
- Q&A: How to Wire 12V Battery in Enclosed Trailer to Power Trailer Lights Independent of 7-Way Connection
- Q&A: Can I Disable Solar Charging on the Go Power PWM Solar Charge Controller w/ Bluetooth?
- Q&A: Is There Replacement Flush Ball for Dometic 310 Toilet
- Q&A: What Stabilizer Jack do I Need to Replace Mine on My 2018 Keystone Impact Fuzion LCI 337199?
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Leaf Spring Bushings Closest to 1-1/4 Inch Outer Diameter
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Article: How to Troubleshoot Your RV Air Conditioner
- Article: How Many Batteries Do You Need to Run an RV Air Conditioner?
- Article: How to Wire an Electric Winch