Length of Replacement Eye Bolt for Meyer, Diamond, and Western Snow Plows
Updated 09/30/2020 | Published 09/29/2020
Question:
Hello, Im looking for a few measurements of this bolt. Could you tell me what the over all length is? What the length of the threads are? The diameter of the hole? And is the thread a 5/8-11? Thank you
asked by: Craig Y
0
Expert Reply:
The Replacement Eye Bolt for Meyer, Diamond, and Western Snow Plows part # 3371302005 has 5/8"-11 threads with an overall length of 6". If you can provide the type of snowplow you have I may be able to confirm fit that way but this is unfortunately as much detail as I can provide on these type of replacement parts.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Replacement Eye Bolt for Meyer, Diamond, and Western Snow Plows
- Snow Plow Parts
- Diamond Plow Parts
- Meyer Plow Parts
- Mounting Parts and Hardware
- Bolts
- SAM
more information >
Continue Researching
- Q&A: Replacement Trailer Light for Wesbar SAE-AIP2ST-DOT94 105826 Tail Light
- Q&A: Recommended Replacement Driver and Passenger Side Lights for a Wesbar SAE-AIP2ST-DOT-01
- Q&A: Replacement 11-Pin Wire Harness Repair Kit for a Fisher 7.5 Snow Plow
- Q&A: Brake Controller Recommendation for a Truck with Air Brakes and a Trailer with Electric Brakes
- Q&A: Where is the Brake Switch to Install a Brake Controller on a 4300 International Truck
- Q&A: Replacement Idler Trailer Hub For a 2014 Load Rite Jet Ski Trailer WV1200WBZTS
- Q&A: Replacement J-1024-A Side Marker Light