How to Install the SuperSprings # SSA7 on a 2011 Toyota Tacoma With Factory Springs Under the Axle
Updated 11/13/2012 | Published 11/10/2012
Question:
On a 2011 Tacoma 2x4 factory springs under axle
asked by: Allen
0
Expert Reply:
To install the SuperSprings, # SSA7, on your 2011 Toyota Tacoma with factory springs mounted under the axle, you will position the spring above the axle and connect the front and rear shackles to the factory leaf springs. The center of the spring will be above the axle as shown in the photo that I attached.
I have also attached the instructions that details the installation process for you to check out.
expert reply by:
John H
0
click to enlarge
Product Page this Question was Asked From
SuperSprings Custom Suspension Stabilizer and Sway Control Kit
- Vehicle Suspension
- Towing/Load Leveling
- Leaf Springs and Helper Springs
- Suspension Only
- Helper Springs
- Light Duty
- Rear Axle Suspension Enhancement
- SuperSprings Intl
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: How to Replace a Lance 6-Pin Plug w/ a Standard 7-Way Connector
- Q&A: Adapter and Re-Wiring Kit for Lance Truck Camper with Round Pin 7-Way Plug
- Q&A: Will Timbre TDDR00 Fit a 2003 Dodge Dakota and Interfere with Brake Line
- Q&A: Recommended RV Camper Tie Downs for 2016 Ford F-250 Super Duty 6-3/4 Foot Bed with Factory Hitch