2005 Mini Cooper r52 Brake Light Switch Pin
Updated 09/24/2020 | Published 09/05/2020
Question:
Do you have the pinout for the 2005 mini Cooper convertible manual trans brake light switch? There are 4 pins. I thought pin 3 was the brake light signal, but the brakes are still illuminated when the relay is inactive and the pedal is pressed.
asked by: Matt B
Expert Reply:
On the brake light switch, part # RM-751438, there are two black wires and they can be connected to either the battery or the supplemental braking system. One black wire can be ran to a fuse or the battery. The other black wire gets connected to the indicator light in the supplemental braking system, commonly the black wire on the light. Roadmaster doesn't require the use of a brake light relay on your Mini.
Product Page this Question was Asked From
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement Breakaway Switch and Cable for Roadmaster Even Brake System
- Q&A: Does Roadmaster Charge Kit for Towed Vehicles Require Installing Diode as Well
- Q&A: Recommended Flat Tow Setup for Blue Ox Tow Bar on 2008 Honda CR-V
- Q&A: How The Roadmaster Even Brake Supplemental Braking System Activates Braking In Towed Vehicles
- Q&A: Is It Normal For The Breakaway Switch Of The Invisibrake To Still Work When Not Hooked Up To Tow
- Q&A: How To Install Brake Controller On 2018 Jeep JL Without Access To Cold Side Of Brake Switch
- Q&A: RoadMaster BrakeMaster Second RV Kit # RM-98300 Wiring into Cold Side of Brake Light Switch