How to Wire a 4-Way Round Trailer Wiring Connector
Updated 07/23/2009 | Published 07/21/2009
Products Featured in This Question
Question:
What is the wiring diagram?
asked by: bob
0
Expert Reply:
There is no standard for wiring the 4-way round connector so you will have to use a circuit tester, part # PTW2993 if you need one, to test the wires and wire the connector according to the wiring of your existing connector. I have posted links to the parts mentioned above and our wiring help page below.
expert reply by:
Robert G
0
Product Page this Question was Asked From
Pollak Heavy-Duty, 4-Pole, Round Pin Socket, Concealed Terminals - Chrome - Vehicle End
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- 4 Round
- Plug Only
- Pollak
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Base Plate and Flat Tow Wiring Kits for a 2011 Jeep Liberty
- Article: Best Vehicles to Flat Tow Behind an RV
- Q&A: Parts Needed to Flat Tow 2008 Honda CR-V Behind Motorhome
- Q&A: Parts Needed to Flat Tow a 2007 Honda CR-V Behind a Motorhome
- Q&A: Availability of Coiled 7-Way that is 12 foot Or Longer
- Q&A: What Comes With Nighthawk All-Terrain Tow Bar for Blue Ox Base Plates
- Article: Trailer Wiring Diagrams
- Q&A: Where is Trailer Running Light Relay on 2007 Nissan Xterra
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Roadmaster Vehicle Specific Base Plates