Diamond RV Lighting T8 LED Bulb Installation and Operation
Updated 07/08/2020 | Published 07/06/2020
Question:
Are the pins on the ends of these tubes only to hold them into the light fixture? No connection to ballast?
asked by: Dan H
0
Expert Reply:
The T8 LED Light Bulb - 180 Degree - 700 Lumens - Cool White - 18" Long - Qty 2 # DI83VR as you stated only uses the wiring connection for power. The pins at the ends simply hold the tube LED in place and are not a connection point for the ballast. You can see the lights work in the attached video without even being installed in a fixture and simply using 12v power supply.
expert reply by:
Jason S
0
Product Page this Question was Asked From
T8 LED Light Bulb - 180 Degree - 700 Lumens - Cool White - 18" Long - Qty 2
- Accessories and Parts
- RV Exterior Lights
- RV Interior Lights
- RV Light Fixtures
- Wiring
- Light Bulbs
- Diamond
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacing 18" Florescent Tube Lights On a 2007 Winnebago Journey 36 With LED Bulbs
- Article: Ugly RV Makeover: How to Change Outdated RV Lighting
- Q&A: Can I Put Kilz Down Before Installing the XTRM PVC Membrane?
- Q&A: Replacement Foot Plate For Lippert 359352 Hydraulic Jack
- Q&A: Recommended Replacement for Atwood GC6AA-9E RV Water Heater
- Q&A: Recommended Replacement for Atwood OD5001CW Direct Water Heater
- Q&A: Replacement For 17788 Lippert In Wall Control Panel
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Q&A: Replacement Power Center For a Magnetek Model 80
- Article: How Much Solar Power Do I Need For My RV?
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Testing Breakaway Systems