Will Curt Class III Hitch for 1999 Ford Windstar Work to Carry a Scooter Chair and Carrier 375 lbs
Updated 08/20/2012 | Published 08/17/2012
Question:
2006 ford windstar. Need hitch for lift for scooter chair. Chair weighs approx 275 and lift is about 100lbs + . Will this work?
asked by: Margaret
Expert Reply:
The Curt Trailer Hitch Receiver # 13085 that you referenced is confirmed to fit your 1999 Ford Windstar and has a tongue weight capacity of 400 lbs so it should carry your chair and carrier setup that weight 375 lbs well.
You will need to check the tongue weight rating of your vehicle to determine that your vehicle has the capacity to do this. In determining the overall towing capacity of a setup you must go with the lowest rated component as the overall capacity.
Check out the installation instructions and install video I attached if you or someone you know is planning on installing the hitch.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 400 lbs TW
- 4000 lbs GTW
- 6000 lbs WD GTW
- 2 Inch Hitch
- 600 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Replacement Lens for SAEAP2 16 DOT Clearance Light
- Q&A: Overall Length of the Replacement Gear Motor Assembly for Power Gear Slide-Out 368200
- Q&A: Replacement LED Top Command Clearance Light With SAE-AP2-16 On Lens For 2018 Sunseeker Motorhome
- Q&A: Recommended Hitch for a 2024 Mazda CX-50
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Idler Hub To Replace TDE 46245 Hub and Rotor On Boat Trailer
- Q&A: Trailer Brakes are Very Weak Even After Adjusting Them
- Article: Rolling on a Budget: Top Wallet-Friendly Platform Bike Racks