Mounting Bolt Pattern on the Valterra Waste Valve for RV Gray Water Tank w/ Cap part # T1001C
Updated 04/24/2020 | Published 04/23/2020
Products Featured in This Question
Question:
HI there Would you be able to give me the dimension of the mounting holes for the valve itself on this product https://www.etrailer.com/RV-Sewer/Valterra/T1001C.html#exp-productdetails=.questions Thank you
asked by: Pasan K
Expert Reply:
The mounting hole on the Valterra Waste Valve for RV Gray Water Tank part # T1001C are 2.5" by 2.5". Should you just need the valve and not necessarily the adapters connected you can use Valterra Bladex Waste Valve Body for RV Gray Water Tank part # T1001VP which uses the same mounting pattern. This will also include new seals and harware. Check out the video on it I have attached.
Product Page this Question was Asked From
Valterra Waste Valve for RV Gray Water Tank w/ Cap - 1-1/2" Diameter - Hub to Male Thread
- RV Waste Valve
- Straight Valve
- Single Waste Valve
- 1-1/2 Inch Valve Body
- Manual
- 1-1/2 Inch Hub
- Stationary Valve
- Valterra
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Converting 4-Way Trailer Connector to 7-Way on 2009 Toyota Highlander
- Q&A: How Do I Adapt a 1-1/2" Gray Water Valve to a 3" Bayonet Sewer Connection?
- Q&A: Replacement Components For A Schwintek Slide Out System
- Q&A: Parts Needed to Drain Gray Water Tank From Valterra T1001C
- Q&A: Slide Trim Availability for 2021 Keystone 5th Wheel
- Q&A: Recommended 32" Long x 24" Wide Bath Tub Base w/a Left Hand Drain
- Q&A: Changing A Waste Drain From 1-1/2 To 3
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Bleed Your Trailer Surge Brakes