Correct Replacement Hanger Kit for Car Trailer
Published 03/07/2020
Question:
I have older parris car trailer. want to know if this will work to replace ? My quick measurements, A=30, B=30,C=35, all 3 hangers to center hole are 2 3/4inch 1 3/4inch wide springs D= 4
asked by: Michael S
1
Helpful Expert Reply:
It sounds like # APT9 is the correct hanger kit for you. Do the 2-5/8 inch shackle straps and 7-3/4 equalizers match your current parts? The hangers of the kit are a 1/4 inch shorter than your current ones but if everything else matches that's not going to be a problem for you.
expert reply by:
Charles S
1
Product Page this Question was Asked From
Tandem-Axle Trailer Hanger Kit for Double-Eye Springs - 2-1/2" Front/Rear/Center
- Trailer Suspension Parts
- Hangers
- Suspension Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Tandem Axle
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Recommended AC System for a RV Prepped for a 2nd AC in the Bedroom
- Q&A: Replacement For A Dexter 8-249 Hub And Drum Assembly
- Q&A: How to Decide Which Tandem Axle Trailer Hanger Kit to Use
- Q&A: Warranty of Phoenix Electric Trailer Jack With Remote
- Q&A: Troubleshooting Ultra-Fab Phoenix Electric Tongue Jack That Won't Extend or Retract
- Q&A: Troubleshooting Bulldog Powered Drive Trailer Jack Switch Working Intermittently
- Q&A: Troubleshooting A Phoenix A-Frame Trailer Jack That Does Not Operate Anymore
- Article: Where to Position the Trailer Axle?
- Article: Determining Trailer Tongue Weight
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: Double-Eye Trailer Suspension System Review
- Article: Slipper Spring Trailer Suspension System Review
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: How to Measure a Trailer Axle