Curt Class III Trailer Hitch Receiver Origin
Updated 06/23/2009 | Published 06/22/2009
Question:
Where is this product made - component parts and manufactured?
asked by: Perry
0
Expert Reply:
This Curt hitch is manufactured in Eau Claire, WI. USA and the hardware is purchased from a USA company also. If you have any further questions let me know.
expert reply by:
Robert G
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 5000 lbs WD GTW
- 2 Inch Hitch
- 500 lbs WD TW
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Will a Trailer Hitch Fit a 2008 Honda Pilot with a Full Sized Spare Tire
- Q&A: Hopkins Trailer Wiring Harness Fit For 2021 Subaru Crosstrek Non-Hybrid
- Q&A: Parts Needed to Tow a Trailer with 2018 Subaru Outback
- Q&A: How to Tell the Difference Between a 4-Bolt and a 10-Bolt 5th Wheel Hitch Mounting Rail
- Q&A: Missing Bolt Holes For Hitch Install on 2006 Honda Pilot
- Q&A: Does Trailer Hitch for 2008 Honda Pilot Come with Everything
- Q&A: How to Replace Drilled Out Lock Core in Thule Roof Mounted Cargo Box
- Article: How Much Does a Boat and Trailer Weigh?
- Article: 4 Reasons Not to Use RV Solar Power (And 4 Reasons You Should)
- Article: Aftermarket Brake Control Wiring for 07-13 GM Full-Size Truck with Factory-Integrated Brake Control
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Choose the Right Trailer Hitch Class