Custom Mount for the Edge CTS3 Tuner On a 2008 Ford F-250

Question

Question:

Looking for a pillar mount for my 2008 f250 for edge california product number 85401. Please advise. Thanks

asked by: Chris C

0

Expert Reply:

I checked with Edge and they do make a custom mount for the Edge Diesel Evolution CTS3 Performance Tuner part # EP96TR and your 2008 Ford F-250, the Custom Dash Pod for Edge Monitors that has a CTS3 adapter is the part # EP28500. However, this is a dash mount and they do not offer a pillar mount for this tuner and your vehicle. Therefore, your only options are the dash mount or window mount.

expert reply by: Conner L

0

Answer 1

When installed on your 2000 Ford F-250 7.3L Diesel Engine, the Edge Evolution CTS3 Performance Tuner #EP96TR that you referenced will give you up to 120 horse power and 315 ft lbs of torque. This tuner will plug right into the truck's OBD-II port…

view full answer...

Answer 2

The Edge Diesel Evolution CTS3 Performance Tuner #EP96TR referenced in your question is confirmed to fit your 2002 Ford F-250 7.3L Diesel. I can't be certain what your local shop is referring to with regards to an existing chip on your truck but…

view full answer...

Answer 3

Since you said you couldn't find a power level option on the Edge programmer you have on your 2008 Ford F-250 there is a great chance you actually have an Insight Monitor like part #EP84030. This product only allows you to look at various engine…

view full answer...

Answer 4

That means the programmer you have was installed on a different vehicle and wasn't returned back to stock before you got it. These can only be programmed to one vehicle at a time, so you'd have to track down the original vehicle the…

view full answer...

Answer 5

For the Edge CS2 Evolution Diesel Tuner you will need to enter the programming menu. You will turn on your vehicle without starting it. Then use the Menu button to open the main menu and scroll down with the arrow to the Programming on the screen.…

view full answer...

Answer 6

With the Edge Diesel Evolution CTS3 Performance Tuner #EP96TR installed on your truck when towing you'd most likely see around 2 more miles per gallon but it's really pretty hard to say. You also can use it on the highest power level too.…

view full answer...

Answer 7

The valve in your regulator is likely going bad and allowing the gas leak so you would want to replace it. I recommend swapping it out with the JR Products Compact Automatic Changeover 2-Stage Propane Regulator #37207-31525. This has 1/4" FIF…

view full answer...

Answer 8

The Curt E16 5th Wheel Hitch that you referenced, part #C16115, is rated for 5th wheel trailers up to 16,000-lbs gross towing weight. Gross towing weight means the trailer weight plus the weight of all loaded water, propane, supplies and equipment -…

view full answer...

Answer 9

Yes, the Air Lift LoadLifter 5000 Ultimate Air Springs #AL88396 will work on your 2016 Ford F-250 with the B&W Turnover Ball #BWGNRK1111 installed. I recommend using the Air Lift WirelessAIR Compressor System #AL74000EZ to inflate your air bags.…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

You can use leaf springs that are rated higher than the axle without any issues as long as they measure the correct measurement for your trailer. For example the 6-leaf double eye spring for 7,000 lb axles part #e64SR measures 24-7/8" eye to…

view full answer...

Custom Mount for the Edge CTS3 Tuner On a 2008 Ford F-250

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching