Arm Diameter on CargoSmart Extended Dual Arm Tool Hook # 3481708
Updated 07/08/2019 | Published 07/05/2019
Question:
Can you tell me the diameter of the bar? CargoSmart Extended Dual Arm Tool Hook for E-Track or X-Track System - 200 lbs
asked by: Kevin
0
Expert Reply:
I went out to our warehouse to take a look at the CargoSmart Extended Dual Arm Tool Hook # 3481708 that you referenced. I measured a diameter of right at 7/16 of an inch for each of the arms. I have attached an image to assist.
expert reply by:
Chris R
0
click to enlarge
Product Page this Question was Asked From
CargoSmart Extended Dual Arm Tool Hook for E Track or X Track System - Steel - 200 lbs
- E Track
- E Track Cargo Organizers
- Hook
- CargoSmart
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: How to Identify Right Versus Left Trailer Ramp Springs
- Q&A: How to Correctly Position Ramp Door Spring for Installation
- Q&A: Replacement Brake Actuator for Tie Down Engineering LP7000
- Q&A: Where to Start When Trying to Determine Axle Placement on a Boat Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Is Length of Replacement Cables for Conventional Ramp Door Spring a Standard Length
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Does Drum Brake Master Cylinder Need to be Replaced with Atwood Master Cylinder for Disc Brakes
- Q&A: Can Rubber Inside Equa-Flex Cushioned Equalizers LC314336 Be Replaced
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Install E-Track in 3 Easy Steps
- Article: Trailer Maintenance Schedule
- Article: Best Ladder Racks