Solution for Trailer Jack that Handle Froze When Fully Extended
Updated 05/06/2019 | Published 05/04/2019
Question:
Shelby750 lb jack, fully extended and locked up, will not lower. Handle frozen.
asked by: Larry F
0
Expert Reply:
It was over-extended and the threads/screw were damaged to the point you can no longer operate your jack. It's time to replace the jack with something like the Pro Series Jack part # PSEJ10000101 that you referenced.
I attached an install video for this for you to check out as well.
expert reply by:
Jameson C
0
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Is there a Trailer Wheel that Fits a 4 on 3 Inch Bolt Pattern
- Q&A: Mounting plate Dimensions for the Pro Series Jack # PSEJ10000101 to Mount on a LAK Sailplane Trailer
- Q&A: Trailer Jack Replacement Recommendation for Pro Series 1,000 lb Jack
- Article: Trailer Wiring Diagrams
- Q&A: Is There a Direct Bolt On Replacement for Shelby 1,000 Lb Boat Trailer Jack
- Q&A: Fulton Jack Recommendation for Triton Dual Axle Boat Trailer with Weld On Fulton Jack
- Q&A: Replacement Swivel Jack for a Champion Boat Trailer
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Recommended 5.30X12 Tire and Wheel with High Speed Rating
- Article: How to Determine Tire/Wheel Diameter
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Lighting Requirements
- Article: Best Camper Jacks
- Article: How to Measure Your Trailer Wheel Bolt Pattern