Does Holding Tank Need to be Drilled to Install the Valterra No-Fuss Flush Accessory Kit
Published 02/28/2019
Question:
Do you have to drill into the holding tank for installation ?
asked by: Drew
0
Expert Reply:
Yes, you will need to modify your holding tank to install the Valterra No-Fuss Flush Accessory Kit # A71.
Essentially what you do is after you drill, or tap, the hole simply take one of the black threaded and barbed pieces and connect it directly to the tank and then put the hose over the barbed end.
expert reply by:
Jon G
0
Product Page this Question was Asked From
Valterra No-Fuss Flush Accessory Kit
- RV Black Tank Cleaner
- Black Water Tanks
- Gray Water Tanks
- Tank Rinsers
- Valterra
more information >
Continue Researching
- Q&A: Replacement Flush Valve and Connector for 2018 Jayco Alante
- Q&A: Replacement Arm for Lippert Edge 12V Power Awning
- Q&A: Replacement Landing Gear For Bulldog 1082816-83 When Screw Head Broke Of Jack Leg
- Q&A: Recommended Replacement for Atwood GC10A-4E RV Water Heater
- Q&A: What Purpose Does Vacuum Breaker Serve on Tornado 360-Degree RV Holding Tank Rinser # CAM40126
- Q&A: Replacement for Atwood 61101 Brake Actuator
- Q&A: Overall Hitch Ball Height for B&W Ball and Safety Chain Kit on a 2024 Ram 3500
- Article: Converting Your RV Water Heater to Tankless
- Article: Cleaning Your RV Black Water Tank in 4 Easy Steps
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Sidewinder with Rotating Turret for Short Bed Pickups