Can Kat's Heaters Oil/Transmission Pan Heating Pad # KH26150 Bend to Fit Smaller Oil Pan
Updated 01/28/2019 | Published 01/27/2019
Question:
Hi. I have a 2009 Mercedes Sprinter. I bought myself a 1000 watt oil pan heater but the oil pan doesn’t have a big enough flat surface for this heater. Is it ok to install the pad and it has a bend in it kinda wraping around onto the side?
asked by: Daniel
0
Expert Reply:
Yes, it would be fine to have the heater pad curve along the surface of the oil pan. As long as all of the pad is contacting the oil pan you are fine.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Kat's Heaters Oil/Transmission Pan Heating Pad - 5" x 4" - 120V - 150W - Grounded Plug
- Oil Pan Heater
- Heating Pad
- 120 Volts
- 150 Watts
- 5L x 4W Inch
- CSA Approved
- Kats Heaters
more information >
Continue Researching
- Q&A: Why Does the RV Holding Tank Heater Have a Separate Ground Wire and Not a 3 Prong Plug?
- Q&A: Will A 125W Heat Pad Be Enough For 6 Quart Oil Pan On Pickup In The Winter?
- Q&A: Can I Install Just One MORryde X-Factor Crossmember Or Do I Need All Three?
- Q&A: Recommended Equalizer Upgrade For 2016 Winnebago 2351DKS W/ 5-1/2" Long Equalizers
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Q&A: How To Wire In Three Thermat Heat RV Tank And Pipe Heater Pads
- Q&A: Wattage Draw For The RV Holding Tank Heater # 372HTH-A