Is Fascia Trimming Required for CURT Front Trailer Hitch Installation on a 2004 Ford Expedition
Published 11/23/2011
Question:
Regarding installation of Curt front mount trailer hitchon a 2004 Ford Expedition 4x4 Eddie Bauerwill trimming of any front facia be required?? Thanks.
asked by: Mark S
0
Expert Reply:
When installing the CURT Front Mount Receiver, # 31352, trimming of front air dam or fascia may be required for hitch installation. Since the Eddie Bauer edition may included some additional appearance panels in the front, it is likely that some trimming will occur. I have included a link to the installation instructions for you to take a look at and compare to your Expedition.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Concealed Cross Tube
- 500 lbs Vert Load
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Can the Center Knockout Panel be Re-Installed After a Trailer Hitch on a 2015 Cadillac SRX
- Q&A: Is Fascia Trimming Required to Install a Front Mount Receiver on a 2005 Ford F-150 4x4
- Q&A: Recommended Factory Replacement Hitch for a 2000 Ford Excursion
- Q&A: Recommended Trailer Hitch Receiver For 2000 Ford Excursion
- Q&A: Procedure for Flat Towing 2007 Ford F-150 Behind Motorhome
- Q&A: Why Are There Extra Hitch Pin Holes on the Gen-Y Adjustable 2-Ball Mount 325-GH-524
- Q&A: Trailer Lights Not Fully Working on a Trailer Towed by a 2007 Ford F-150 with Factory Tow Package