Parts Needed to Flat Tow 2018 Ram 2500

Question:

Looking for all the parts I need for above, [email protected]

1

Helpful Expert Reply:

The first thing you need to flat tow your 2018 Ram 2500 4x4 is the correct base plate kit which will give you the connection point for a tow bar to attach. For that we have the Roadmaster MS Base Plate Kit part # RM-296-2 which is a confirmed fit and would work well. This would work great with the tow bar part # RM-422 you referenced as well.

For safety cables you can use # RM-643. The coiled design helps keep the cables off of the ground.

For lighting you can use the diode kit, # RM-15267, and not have to worry about cutting into the taillight housing. This will splice into your taillight wiring to allow your tow vehicle to control the taillight assemblies of the towed vehicle. This comes with a round 6-way connector that you will install on the front of your towed vehicle and enough coiled wire to go from there to the RV.

And finally, most states now require supplemental braking in the vehicle being flat towed. The easiest system to set up and use is the Blue Ox Patriot # BRK2016, that applies the vehicle brakes in proportion to how much the tow vehicle is braking. This is the safest way to stop and it reduces wear and tear on both vehicles.

Most likely you will also need a high low adapter so that the tow bar will be level when you are flat towing. I attached a link to a page that has all of the ones we carry.

I have included a couple of helpful links to our articles on flat towing for you. Be sure to consult the vehicle owners manual for more specific information on flat towing your vehicle.

helpful expert reply by:
1
Jameson C

Ask The Experts a Question >>


Products Referenced in This Question





Product Page this Question was Asked From


Similar Expert Q&A Pages

See More Q&A Expert Answers >>