Troubleshooting Lifting Corner of Extang Trifecta Tonneau Cover on 2018 Chevy Colorado
Published 08/02/2018
Products Featured in This Question
Question:
front corner wants to raise up in wind . is there an extra clamp you can put on that corner? 2018 Chevy Colorado
asked by: Joe M
Expert Reply:
I reached out to my contact at Extang and the front corner raising is a sign of the clamps not being installed correctly. He said you will want to remove the front clamp by removing the knob and then rotating the body up until the thread shows only about a 1/4 inch. Then reinstall the knob and secure the cover. He said you will want to do this on both sides of the bed. That will tighten the tension on the cover in the front and will also give you a better seal.
No additional clamps or hardware should be necessary. I've attached the installation details to assist. This is for the 5 foot bed # EX92350 or # EX94350 and the 6 foot bed # EX92355 or # EX94355.
Product Page this Question was Asked From
Extang Trifecta 2.0 Soft Tonneau Cover - Folding - Vinyl
- Tonneau Cover
- Fold-Up - Soft
- Opens at Tailgate
- Tailgate Lock
- Standard Profile - Top of Bed Rails
- Vinyl
- Vinyl Grain
- Extang
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Is etrailer Trailer Hitch Compatible With 2025 Mercedes-Benz eSprinter 2500
- Q&A: Recommended Folding Tonneau Cover for a 2024 Chevrolet Silverado 2500 Pulling a 5th Wheel Trailer
- Q&A: Comparing the Universal Installation Kit # ETBC7 and the 7-Way RV Upgrade Kit # ETBC7L
- Article: Trailer Wiring Diagrams
- Q&A: Equipment Needed For Flat Towing Vehicle Behind Motor Home
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited
- Q&A: Recommended Trailer Hitch and Wiring for 2022 Mercedes-Benz Sprinter 2500 with Step Under Bumper
- Q&A: Parts Needed For Installing Trailer Hitch Receiver & Wiring For Brake Controller 2022 Sprinter 2500
- Q&A: Replacement Foot Base for Thule Tracker Roof Rack