Will the Firestone Coil-Rite Air Helper Springs Kit # F4174 Fit on a 2006 Toyota Rav4 Sport
Updated 02/19/2013 | Published 07/26/2011
Question:
Is this the correct part for my vehicle? I have a 2006 Toyota Rav4 Sport. From what I understand, this submodel has a lower suspension and I wanted to make sure this part still applies. Thank you in advance.
asked by: Ed S
Expert Reply:
I spoke with my contact at Firestone and the Firestone Coil-Rite Air Helper Springs Kit, # F4174, will fit in a coil spring that is at least 4 inches diameter, inside width, and 6 inches tall inside. He said that they do not have any notes about fit on a sport model of the 2006 Toyota Rav4, so he believes the # F4174 kit will work, but that you should measure the rear coil springs to be sure.
If your measurements are slightly larger than 4 inches diameter and 6 inches height, then this kit will work great. If the measurements are smaller, then the kit will not fit your vehicle.
Product Page this Question was Asked From
Firestone Coil-Rite Air Helper Springs - Rear Axle
- Vehicle Suspension
- Towing/Load Leveling
- Air Springs
- Suspension Only
- Light Duty
- Rear Axle Suspension Enhancement
- Firestone
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Brake Controller and Weight Distribution for 2019 Honda Pilot Towing 2026 Geo Pro 17LE
- Q&A: Do I Need a Weight Distribution System for a 2024 Jeep Grand Cherokee and a 3,160 lbs Trailer?
- Q&A: How To Tow a Trailer and Haul a Motorcycle with a 2012 Toyota RAV4
- Q&A: Recommended Hitch for a 2011 Toyota RAV4
- Q&A: How To Mount a Trailer Connector To The Draw-Tite Hitch 76138 On a 2018 Mazda CX-5
- Q&A: Is Fastway e2 Weight Distribution System Compatible With Surge Brakes on 7,000 Lb Trailer
- Q&A: Hitch, Weight Distribution and Brake Controller Recommendations for a 2017 Toyota Sienna XLE
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Frequently Asked Questions About Transmission Coolers
- Article: How to Measure for Trailer Hitch Drop
- Article: Performance Chips and Modules
Dave S.
2/19/2013
Over the weekend I just installed this kit on my 2006 V6 RAV4 Sport. It does fit and works well. I keep 8lbs in it without my vehicle loaded and no trailer attached. I will increase the pressure as required. I do not need separate pressures from left to right so I purchased a 14 brass Tee fitting and routed a single air line to the rear bumper for airing up/down.