Will the Draw-Tite Hitch # 75034 Work on a 1978 Chevy C-10
Updated 07/27/2011 | Published 07/26/2011
Products Featured in This Question
Question:
Will this hitch fit 1978 c-10 2 wheel drive heavey duty suspension factory installed stepbumper with no modifacations needed for installation of this hitch?
asked by: Richard
Expert Reply:
The only modifications you will need to make on your 1978 Chevy C-10 2WD to install this Draw-Tite Max-Frame Trailer Hitch # 75034 will be that you will need to drill a few holes and relocate the spare tire mount.
I attached installation instructions for you to check out for this product.
You may also be interested in purchasing the following products to complete your tow setup:
T-One Vehicle Wiring Harness with 4 Pole Trailer Connector # 118311 (instructions attached)
Ball Mount # 2753
Hitch Ball with 2 inch Diameter and Medium Shank # 19247
Pin and Clip # PC3
Continue Researching
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Why Is Trailer GVWR Higher Than Combined Capacity of its Axles
- Q&A: Should 1 or 2 Axles Have Brakes on Tandem Axle Trailer
- Q&A: Adding Brakes to a Mobile Home Axle
- Q&A: Do Mobile Home Axles Have Weight Capacity Rating
- Q&A: Can the Line on an Electric Winch Come Out at an Angle on a Boat Trailer
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Replacement Tires for Old Travel Trailer Tires G78-15