How Does Brake Controller Install in 2007 Chevy Suburban
Published 10/24/2017
Question:
I currently have a 2000 Chevy Suburban 1500 LT with a Tekonsha 9030 Voyager brake control. I recently purchased a 2007 Chevy Suburban 1500 LT. Would I be able to transfer this brake controller into my newer Suburban? The 2007 Suburban is tow ready with the Bargman socket in the rear. It just needs a brake controller installed.
asked by: Jamie M
Expert Reply:
Your 2007 Chevy Suburban is ready to have a brake controller installed, but no plug is present under the dash, but the needed wires are already run. You will connect the brake controller wiring with the vehicle wiring already present under the dash.
The install video I attached will walk you through the process.
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Parts Needed To Add Electric Drum Brakes To A Trailer
- Q&A: Can Electric Over Hydraulic Brake Actuator Be Fully Submerged
- Q&A: Replacing 6-Way on Trailer With 7-Way Connector
- Q&A: Will the HydraStar Electric Over Hydraulic Actuator Part # HS381-8067 Work for Me
- Q&A: Differences Between Marine and Standard Hydrastar Actuators
- Q&A: Recommended Actuator and Wiring for Boat Trailer Upgrade From Surge Brakes
- Q&A: Converting Surge Brakes to Electric Over Hydraulic on a Tandem Axle Boat Trailer