Availability of a 4-Flat and 5-Flat Wiring Harness to Power an Air Compressor on a Trailer
Updated 06/20/2017 | Published 06/19/2017
Question:
I have an Adventure motorcycle trailer model AST 1 SE it has a 12 volt air 20 Amp compressor to raise and lower the trailer and and maintain its height while in tow and has a 5 pin connector can I get a 5pin connector on part #118519 or do I need to use a 4 to 5 pin convertor also can I splice into the battery wire providing power to the Tekonsha 11859 or do I need another feed wire. This unit will be used on a 2013 Lincoln MKX all wheel drive
asked by: John A
Expert Reply:
With the set up on your 2013 Lincoln MKX, you best option will be to install the T-One Vehicle Wiring Harness, # 118519, and then use the Tow Ready 4 Pole to 5 Pole Wiring Adapter, # 20036.
This the adapter will connect your 4 pole vehicle plug and 5 pole plug on your trailer. The trailer lights will be connected to your vehicle. The extra wire then can be wired up to the battery to power your air compressor. Depending on the amp draw of your compressor, I also recommend you wire in a fuse holder, like # SWC9545, according to the proper amperage.
Continue Researching
- Q&A: My Vehicle has a 4-Pin Trailer Plug, but Trailer has 7-Pin Trailer Plug
- Q&A: Trailer Wiring Harness Options for a 2011 Lincoln MKX
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Recommended 4-Way and 7-Way Wiring Harness for a 2014 Lincoln MKX
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Anti-Rattle Devices