Bolt Hole Dimensions Of Demco Brake Actuator # DM8669112
Updated 03/28/2017 | Published 03/27/2017
Question:
what is the mounting bolt distance? the one im replacing is 3inch from the front bolt to the center bolt and 12.5inch from the front bolt to the back bolt.
asked by: Jeff F
Expert Reply:
The mounting holes of the Demco Hydraulic Brake Actuator w/ Drop - Drum - Zinc - 2" Ball - 8,000 lbs # DM8669112 are in the same exact locations as you mentioned. From front bolt to second bolt center to center is 3 inches. From the front bolt to the rear bolt center on center is 12-1/2 inches. This bolt-on installation requires 1/2 inch by 4-1/2 inch Grade 5 bolts that are not included. I've attached a photo to help.
Product Page this Question was Asked From
Demco Hydraulic Brake Actuator w/ Drop - Drum - Zinc - 2" Ball - 8,000 lbs
- Brake Actuator
- Surge Brake Actuator
- Boat Trailer
- Construction Trailer
- Farm Trailer
- Travel Trailer
- Utility Trailer
- Bolt-On
- 8000 lbs GTW
- 2 Inch Ball Coupler
- 3 Inch Channel Tongue
- Drum Brakes
- No Lockout
- Demco
more information >
Continue Researching
- Q&A: Does the Demco DM72VR Replace an Atwood 171 Actuator and Can I Add a Reverse Lockout?
- Q&A: Replacement for a TDE LP8500 Boat Trailer Acuator
- Q&A: Replacement Lockout Lever Kit for Demco DA86 Surge Brake Actuators
- Q&A: Troubleshooting Blown Vehicle Fuses Every Time Trailer is Connected
- Q&A: Adding Manual Lockout to Surge Brake Actuator
- Q&A: Reverse Lockout For a Dexter DX 12.5 Disc Brake Actuator
- Q&A: Will Manual Lock Out Kit for Demco DA75 Actuators Fit Demco DA70
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Most Popular Wheel Bearings