Rear Suspension Enhancement Recommendation for 2016 Hyundai Santa Fe  

The towing capacity of the 2014 Hyundai Santa Fe varies depending on the specific engine and transmission in the car and on whether or not the trailer has brakes. Minimum capacity is 1653-lbs for trailers without brakes and the maximum for the manual…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

We know the Firestone air bag kit part #F4170 is a fit for your 2014 Hyundai Santa Fe because we had the chance to install them on a similar 2015 and 2013 model and they fit and worked well. If you check out the install video I attached below you can…

You can use Air Lift Replacement Rear Air Spring #AL60315 for the rear axle kit #AL60820 that is installed in your 2011 Jeep Liberty. If you do not already have a compressor and you are always manually inflating the springs you might consider adding…

In the instructions that I have linked for you, under Figure B it states the recommended operating pressures for Firestone air springs #F4174 are from 5 psi to 35 psi. So 35 psi is the max you will want to put in the bag in this system. In step 9 it…

In order to find the right replacement bearing kit for your Jayco Qwest 8U Pop-Up Camper you will need to pull one of the hubs. Once you have the hub off the trailer remove the inner and outer bearings and check for a number that should be stamped…

To determine if we have a wheel bearing that will be compatible, you will need to use a digital caliper and take some measurements of your existing spindles. If you reply with the B, C and D dimensions you find (as shown in the diagram I provided), I…

I have attached a chart you can check out that describes the torque needed per wheel size, wheel stud size and material. For an 8-inch wheel with a 1/2-inch wheel stud the torque is 75 to 86 ft-lbs. For a 15 inch steel wheel with 1/2 inch wheel studs…

The anti-rattle adapter I recommend is the No-Rattle Trailer Hitch Wedge, part #MPG908. This will work for 1-1/4 inch and 2 inch receivers and is designed to insert into the small gap that may exist on your receiver. You then tighten it up after it…