Can Oil Pan Engine Heater KH26150 Be Bent to Fit Oil Pan
Published 01/04/2017
Question:
the bottom of the oil pan is smaller on this 2009 Subaru Forester than the 4inch by 5inch pad. Can i bend it around one side of the oil pan? or does it have to be flat?
asked by: Noel
1
Helpful Expert Reply:
Yes you can bend the edge of the engine heating pad part # KH26150 if needed to fit your 2009 Subaru Forester.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Kat's Heaters Oil/Transmission Pan Heating Pad - 5" x 4" - 120V - 150W - Grounded Plug
- Oil Pan Heater
- Heating Pad
- 120 Volts
- 150 Watts
- 5L x 4W Inch
- CSA Approved
- Kats Heaters
more information >
Continue Researching
- Q&A: Suspension Enhancement For A 2 Wheel Drive 2001 Toyota Tacoma
- Q&A: Installation of Kat's Heaters Cartridge Heater for 2008 Scion tC
- Q&A: Can I Install Just One MORryde X-Factor Crossmember Or Do I Need All Three?
- Q&A: Trailer Brakes are Very Weak Even After Adjusting Them
- Q&A: How to Attach Magnetic Emergency Light to Aluminum Body Truck
- Q&A: How Much Does The BulletProof Hitches Aluminum Adjustable 2-Ball Mount - 2-1/2" Hitch Weigh?
- Q&A: Why Does the RV Holding Tank Heater Have a Separate Ground Wire and Not a 3 Prong Plug?