Can Trailer Wiring Harness Power Wire be Ran through Firewall on a 2010 Lincoln MKT
Updated 10/31/2016 | Published 10/28/2016
Products Featured in This Question
Question:
2010 Lincoln MKT with eco boost wire routing Trying to go through the firewall after routing the wire through the inside of the car. Any suggestions?
asked by: Jacob
Expert Reply:
If there isn't an easily accessible point of entry into the engine compartment through the firewall on your 2010 Lincoln MKT then you will need to drill a small hole to run the wiring harness power wire. There are a couple of things to be aware of. First, be careful that the other side of the firewall is clear. And second after making the hole and route the wire through it be sure to seal it up with silicone such as # LT37464.
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Powered Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Visible
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Recommended Trailer Hitch for a 2016 Lincoln MKT
- Q&A: What is the Weight Rating for the Benton Shifts&Grins 2-Bike and 4-Bike Racks
- Q&A: Is the Benton Shifts&Grins Bike Rack Available in 4-Bike Setup
- Q&A: Tankless RV Water Heater Replacement For Atwood GC10A-4E
- Q&A: Replacement Standard tank Water Heater For an Atwood 6G Water Hearter
- Q&A: Tail Light and License Plate Kit Recommendation for a Kuat NV 2.0 Bike Rack
- Q&A: 2019 Hyundai Ioniq Plug-In Hybrid Wiring Kit Recommendation for Thule Bike Rack Tail Lights