Angle of the A-Frame Trailer Coupler CA-5100-Z
Published 10/14/2016
Question:
What is the angel of the coupler ?
asked by: Devon R
0
Expert Reply:
Nearly all A-frame trailer have a 50 degree angle frame so when it comes time to replace the coupler it's actually not that hard to pick out a replacement since basically any A-frame coupler will fit.
The coupler part # CA-5100-Z that you referenced is also 50 degrees.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
A-Frame Trailer Coupler - Trigger Latch - Zinc - 2" Ball - Weld On - 5,000 lbs
- A-Frame Trailer Coupler
- Standard Coupler
- 50-Degree Frame
- Weld-On
- 5000 lbs GTW
- 2 Inch Ball Coupler
- Trigger Latch
- 2-1/4 Inch Hole
- Marine Grade
- etrailer
more information >
Continue Researching
- Q&A: What do I Need to Go from Electric Brakes from Hydraulic with Surge Brake Actuator?
- Q&A: Replacement Disc Brake Kit for Mastercraft Trailer
- Q&A: Replacing Older Tie Down Engineering 46210 and 46845 Trailer Hubs
- Q&A: Replacement Leaf Spring For Dexter Leaf Spring # 072-099-01
- Q&A: Hub and Drum Assembly with 8 on 6-1/2 Bolt Pattern for Dexter 10,000 Pound Trailer Axle
- Q&A: Replacement for Shelby 5101 Coupler
- Article: Trailer Wiring Diagrams
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Q&A: Grease Seal Recommendation to Replace AD2527E
- Article: Trailer Lighting Requirements
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure a Trailer Axle
- Article: Carrying on a Legacy: One Family’s Story of Grief, Growth, and a Global Pandemic