What is the Mounting Hole Spacing for Erickson Rope Ring Tie-Down Anchor # EM59113
Updated 09/28/2016 | Published 09/27/2016
Question:
How far apart are the distance between the screws on the surface mount? Want to find out if I can mount it on the shorter side of a 2x4 stud. Thanks.
asked by: Susie
0
Expert Reply:
The mounting holes for Erickson tie down # EM59113 are spaced 1 inch apart side to side on center and 2 inches on center from one set to the other. I have included a picture showing this for you. The picture shows the raw finish model but it is the same for the black one.
expert reply by:
Michael H
0
click to enlarge
Product Page this Question was Asked From
Erickson Rope Ring Tie-Down Anchor - E-Coated Steel - Surface Mount - 2,000 lbs
- Trailer Tie Down Anchors
- Rope Rings
- Universal
- Epoxy Coated Steel
- 2000 lbs
- Bolt-On
- Folding
- Surface Mount
- Erickson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: What is the Difference Among Single Stage Regulators for RVs and Trailers
- Q&A: What Rope Rings will Work on My 2005 Starcraft Camper?
- Q&A: Can Holes in Back of MB Sturgis 108220 2-Stage Propane Regulator Be Used for Mounting
- Q&A: How Does Malone Installation Hardware for Hobie Style Carriers Work
- Q&A: Parts Needed To Tow The Low Bed Micro Sport Trailer With A 2018 Toyota 4Runner With A 2" Hitch
- Q&A: Spare Tire Carrier Retractable Tongue and Kickstand for Malone MicroSport Trailer
- Q&A: Will Malone Spare Tire Carrier MPG465 Work With The Malone LowBed MicroSport Trailer MPG464-LB?