Pipe Mounts for 5K Bulldog Square Trailer Jack
Published 09/09/2016
Products Featured in This Question
Question:
I want to order the weldment for the Bulldog square jack. It has a flange that fits over the sides of the square jack and then is welded to the jack frame. This weldment has a round adapter with 4-holes in it. this allows the jack to be rotated into an up position parallel with the ground or to be removed from the trailer. If you need a photo, I can send it to you.
asked by: Lyle S
Expert Reply:
What you are describing is called a pipe mount for a swivel jack. We have some such as # BD500339. The inner tube diameter is 2 inches and it uses a 5/8 inch pin, # BD500231. If you need the other end that mounts to the trailer it is # BD015279.
Product Page this Question was Asked From
Bulldog Square Jack w/ Footplate - Drop Leg - Sidewind - 28-1/2" Lift - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Side-Mount Jacks
- Standard Grade
- 4001 - 5000 lbs
- Manual Jack
- 29 Inch Lift
- Weld-On
- With Rectangle Foot
- Bulldog
more information >
Continue Researching
- Q&A: Are Radius End And Flat End Slipper Springs For A Trailer Interchangeable?
- Q&A: Recommended Drop Shank for Weight Distribution Systems
- Q&A: Where Does O-Ring of Dexter Vault Kit # DX52UR Go
- Q&A: How to Know When Trailer Brake Magnets are Worn Out and Need Replacing
- Q&A: Replacement Converter For Parallax 7300 Series
- Q&A: What are the Dimensions of a #99 Spindle
- Q&A: Replacement Caliper Solution for Tie Down Engineering 46304
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: How Many Batteries Do You Need to Run RV Air Conditioner?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: The Upgrades: Firestone Air Command Kits
- Article: Trailer Wiring Diagrams
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Trailer Maintenance Schedule