Roadmaster Falcon Tow Bar Base Pin Needed
Updated 10/05/2010 | Published 09/30/2010
Products Featured in This Question
Question:
I have a Roadmaster Falcon 5250 8-10 years old tow bar and need new base pins. The inside measurement on the tow arm is 3/4. The pins on your site are 7/8 and 5/8. Would there be a 3/4 pin available?
asked by: Peter C
0
Expert Reply:
I have heard back from my contacts at Roadmaster about the pin you were needing. Part # RM-910008-00 which is the 5/8 inch diameter Linchpin and Chain is the correct replacement for your Falcon Tow Bar.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Replacement 3/4" Diameter Pin with Linchpin and Cable for Roadmaster Tow Bars - Qty 1
- Accessories and Parts
- Tow Bar
- Pins and Clips
- Roadmaster
more information >
Continue Researching
- Q&A: Recommended E-Bike Bike Rack for a 1-1/4" Hitch on a Flat Towed Vehicle
- Q&A: Do I Need a Charge Line Kit To Flat Tow My 2025 Ford Escape Plug-In Hybrid
- Q&A: Replacement Wheel for 2017 Ford E-450 Class C Motorhome
- Q&A: Replacement Command Center Tablet for Curt RVibrake 3 Portable Braking System
- Q&A: Length of Replacement Base Pins for Curt Rambler Tow Bar # C85WR
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Q&A: Hub and Rotor Replacement Kit for ALKO 12k Axles
- Q&A: What is the Difference Between a Manual Lockout and No Lockout Brake Actuator
- Article: Flat Towing Package for 2025 Ford Escape
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Roadmaster Vehicle Specific Base Plates
- Article: Base Plate Adapter Table
- Article: Can You Flat Tow a Ford Escape?
- Article: Tow Bar Wiring Overview