Where Is Trailer Wiring Harness Connector On 1992 Isuzu Trooper
Updated 07/08/2016 | Published 07/07/2016
Question:
Maybe I have looked closely enough but I can NOT find the trailer wiring connection on my 92 Izzy trooper. Can you help?
asked by: B D
Helpful Expert Reply:
The Curt trailer wiring harness, part # C55339 Is installed to the factory wiring harness connector located on the driver's side of the back of your 1992 Trooper. The connector should be attached to a grommet between the rear wheel well and the bumper on the exterior of the vehicle. It may also be near an exhaust pipe.
With the vehicle is older it could be covered with dirt and tough to find.
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Visible
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Trailer Wiring Solution for 1994 Isuzu Trooper
- Article: Slipper Spring Trailer Suspension System Review
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: Brake Controller Recommendation for 1998 Isuzu Trooper Towing Camper Trailer
- Q&A: What are the Differences in the AM20334 and the AM20304
- Q&A: Avaialbility Of Trailer Hitch For 2000 Toyota Granvia/Grand Hiace
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Q&A: Working Running Lights, But No Turn Signals or Brake Lights On Trailer
- Q&A: How To Install New 4-Way on Trailer with Brown/Green and Brown/Yellow Wires
- Q&A: Why Does 4-Pin Trailer Wiring Have 5 Wires