Will Fulton 1500 lb Bolt-Thru Swivel Jack Fit the Same Mount on Older Fulton Swivel jack

Updated 06/06/2016 | Published 06/05/2016

Products Featured in This Question

Fulton Boat Trailer Jack w/ Wheel - Weld On - Sidewind - Swivel - 10" Lift - 1.5K

(1729)

$187.17

Jack Mounting Bracket for Fulton Marine Jack - Weld-On

(59)

$18.70

Question:

I had a fulton trailer jack recently break on me and i was looking to get one thats similiar i dont have the part number on the old one and this one looks the closest. I have the freame thats still welded on the boat that has a bolt that goes in the middle of the jack on the frame. Will this one fit on the old bracket? Thanks

asked by: Kurtis R

Expert Reply:

Fulton bolt-through trailer jack # F1411300301 is the only Fulton jack that mounts using that 1 center bolt. Since your old jack was a Fulton it must either be this same jack or an earlier model but they use the same mount.

The mount in question and what is on your trailer is # P9012-00. On the off chance that the mount you have is slightly different then you could always use this one as a replacement. The 4 holes are 3 inches apart on center. The bolt that it uses is a 1/2 inch bolt, 1-1/16 inches long. The nut is a matching 1/2 inch coarse thread nut. If that matches what you have then this Fulton jack will fit. If not you could also purchase mount # P9012-00.

expert reply by: Michael H