Distance Between Mounting Holes on the Pollak 4-Way Round Connector
Published 05/03/2016
Products Featured in This Question
Question:
What is the distance center to center between the mounting holes ? My Blue Ox baseplate has two mounting studs 2 3/4 inch apart.
asked by: Thomas C
0
Expert Reply:
I grabbed a Pollak Heavy-Duty, 4-Pole, Round Pin Trailer Wiring Socket, # PK11404, from our warehouse to measure and found the distance between the mounting holes on center is 1-3/4 inches.
If you check out the picture I attached you will see that you would have to come up with a shackle type adapter to allow this connector to be used on your base plate.
expert reply by:
Jameson C
0
click to enlarge
click to enlarge
Product Page this Question was Asked From
Pollak Heavy-Duty, 4-Pole, Round Pin Socket, Concealed Terminals - Chrome - Vehicle End
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- 4 Round
- Plug Only
- Pollak
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Base Plate and Flat Tow Wiring Kits for a 2011 Jeep Liberty
- Article: Best Vehicles to Flat Tow Behind an RV
- Q&A: Availability of Coiled 7-Way that is 12 foot Or Longer
- Q&A: What Comes With Nighthawk All-Terrain Tow Bar for Blue Ox Base Plates
- Article: Trailer Wiring Diagrams
- Q&A: Where is Trailer Running Light Relay on 2007 Nissan Xterra
- Q&A: Does the 2019 Toyota Sienna XLE have Tow Prep Package
- Q&A: Does It Matter Which Side of Battery Is Disconnected to Flat Tow 2024 Chevy Silverado 1500
- Q&A: Replacement 3500-lb Electric Tongue Jack for Lippert 1817941
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Roadmaster Vehicle Specific Base Plates