Where Is Tornado 360-Degree RV Holding Tank Rinser Installed On Holding Tank
Updated 04/11/2016 | Published 04/06/2016
Question:
Do you install the tornado 360 on the bottom of the tank in the center?
asked by: Scott
0
Expert Reply:
Per the installation instructions, the best place to mount the Tornado 360-Degree RV Holding Tank Rinser, part # CAM40126 is on the opposite end of the flush valve.
You can use the template included with the Tornado and measure down about 2 inches from the top and in the middle of the tank. Then tape the template to the tank and drill the mounting holes and center hole for the Tornado to be inserted into the tank, using silicone sealant to make sure there are no leaks.
expert reply by:
Jeffrey L
0
Product Page this Question was Asked From
Tornado 360-Degree RV Holding Tank Rinser w/ 6' Long Hose
- RV Black Tank Cleaner
- Black Water Tanks
- Gray Water Tanks
- Tank Rinsers
- Camco
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Correct Way to Wire Trailer Breakaway Kit
- Q&A: Parts Needed to Convert 3,500 lb Trailer Axle to Disc Brakes
- Q&A: Wiring Diagram to Use When Installing Atwood Water Heater Switch AT91959
- Q&A: RV Refrigerator Replacement For A Dometic DM2652 RBX Refrigerator
- Article: Cleaning Your RV Black Water Tank in 4 Easy Steps
- Q&A: Can B and W Companion Hitch be Used with Turning Point Pin Box
- Q&A: How to Check for a Bent Trailer Axle Spindle
- Q&A: Which SumoSprings Are Best for My Thor Freedom Elite 28FE on Ford E450 Chassis?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: The Definitive, Step-by-Step Flat Towing Setup Guide
- Article: How to Raise Your Travel Trailer Height
- Article: 4 Reasons Not to Use RV Solar Power (And 4 Reasons You Should)