Can Brass Fittings of the Camco RV Winterization Bypass Kit Be Attached to Aluminum w/o Corrosion
Updated 03/29/2016 | Published 03/26/2016
Question:
Any problems threading brass fittings into an aluminum water heater causing corrosion?
asked by: Fred
0
Expert Reply:
Dissimilar metals like brass and aluminum will eventually corrode if left together for extended periods of time. These two metals typically take years for the aluminum to corrode. The plumbers tape that comes with the # CAM35953 is designed to protect the metals from contacting each other. If you use enough of the tape you wouldn't have any contact and would be just fine.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Camco RV Winterization Bypass Kit w/ 8" Hose for 6 Gallon Water Heater - Permanent
- Accessories and Parts
- RV Water Heater
- Winterization
- Permanent Bypass Kit
- Camco
more information >
Continue Researching
- Q&A: Where are the Brake Controller Wires on a 2025 Chevy Traverse?
- Q&A: Does The DeeMaxx Disc Brake Kit DE66YR Use The Single Disc Brake Assembly DE89YR?
- Q&A: How To Install RV Water Heater 3-Way Bypass Valve
- Q&A: DeeMax Disc Brake Kit Recommendation for Dual Axle Trailer with Lippert 3,500 lb Axles
- Q&A: Replacement Dexter Brake Assemblies for 36-19 Assemblies
- Q&A: Recommended Replacement For A Fan-Tastic Vent Model 6504-414
- Q&A: Dexter or Hydrastar Electric Over Hydraulic Actuator for Trailer
- Article: How to Install an RV Awning From Scratch
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited