Ball Mount Hole Reducer Bushing for 1-Inch Thick Ball Platform
Updated 03/10/2016 | Published 03/09/2016
Question:
What shaft hole reducer would you suggest to go from this 1-1/4inch to 1inch ? Looks like all reducers are about 1/2inch deep and this hitch is 1inch thick. Wouldnt that leave some slop in the ball shaft?
asked by: Jim G
0
Expert Reply:
You can use Reese Reducer Bushing part # RP80106 to install your hitch ball in your 1-inch-thick ball mount.
expert reply by:
Adam R
0
Product Page this Question was Asked From
Draw-Tite Ball Mount for 2" Hitches - 5" Rise, 6" Drop - 10-1/4" Long - 16K
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- Steel Shank - Gloss Black
- Drop - 6 Inch
- Rise - 5 Inch
- Fits 2 Inch Hitch
- 16000 lbs GTW
- Draw-Tite
more information >
Continue Researching
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Solution for Hitch Extension With 1,000 Pound TW and 10,000 Pound GTW Capacity on 2000 F-350
- Article: Hitch Adapters and Extenders
- Q&A: Will The Draw-Tite Trailer Frame Hitch Receiver Fit A 1974 Chevy K5 Blazer With A Gas Tank Shield
- Q&A: Dimensions of the A-Frame Trailer Coupler # CA-5280-RB
- Q&A: Parts Needed to Add Brake Controller to 2020 Toyota Tacoma Without Tow Package
- Q&A: What Is The Angle For The etrailer A-Frame Trailer Coupler?
- Q&A: Replacement Trailer Tail Light for SAE Number AISTO1
- Q&A: Ground Clearance with Draw-Tite Trailer Hitch 75782 Installed on a 2016 Ford Escape
- Article: How to Measure for Trailer Hitch Drop
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Trailer Tire Sizing
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: How to Choose the Right Trailer Hitch Class