Recommended Trailer Cargo Ramps For Can Am Spyder Motorcycle
Updated 01/26/2016 | Published 01/25/2016
Question:
need a loading ramp with the dimension, 60 width. the length can be 3 or 4 ft I have a Can-Am Spyder to load onto my trailer, need ramp to support 3 wheel trike
asked by: Neece H
Expert Reply:
I did some research on the Can Am and found that it measures 61.9 inches wide. We do not have any one piece loading ramps that are that wide but I may have a solution.
I recommend using three of the Erickson Arched Loading Ramp, part # EM07464. This ramp is a bit longer than the 3 or 4 feet you mentioned. The ramp is 80 inches long and 11 inches wide. It can be folded for easy storage when not in use. Each ramp weighs 30-lbs and has a weight capacity of 800-lbs.
Product Page this Question was Asked From
Erickson Arched Loading Ramp - Center Fold - Steel - 80" Long x 11" Wide - 800 lbs
- ATV Ramps
- Single Ramp
- Center-Fold
- 11 Inch Wide
- 800 lbs
- Arched
- 80 Inch Long
- Steel
- Erickson
more information >
Continue Researching
- Shop: Erickson Arched Loading Ramp - Center Fold - Steel - 80" Long x 11" Wide - 800 lbs
- Q&A: Recommended Ramps To Load Can Am Spyder On Trailer
- Q&A: Installation Position Of Anderson 3200 Fifth Wheel Rail Hitch
- Q&A: Options for Towing A Fifth Wheel With A 2022 F-350 Short Bed With OEM Puck System
- Q&A: Lift Kit for Trailer with Tandem 5,200 lb Axles
- Q&A: Bike Rack and Cargo Carrier Combination Recommendation for Hitch
- Q&A: Ramp that Can Help Get E-Bike into Truck Bed
- Q&A: Transporting Motorcycle and Camper with Short Bed Truck