Can Edge Programmers be Unplugged After They Are Done Programming PCM
Published 11/23/2015
Question:
does the edge diesel cts2 have to remain connected to the obdII port or can I have program it and then disconnect it. I dont want it mounted in the vehicle.
asked by: Mark
0
Expert Reply:
Once you are done programming your vehicle you could unplug the Edge Diesel Evolution CTS3 # EP96TR from your truck and the tune would stay on the vehicle. You will need to be sure that the programmer is completely done programming the PCM before you unplug it though.
I attached an install video for this programmer as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Edge Diesel Evolution CTS3 Performance Tuner - Color Screen
- Performance Chip
- Performance Tuners
- With Monitor
- Color Touch Screen
- Yes - California Approved
- Evolution
- Edge
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Best Suspension Enhancement Option for a 2014 Ford F-250
- Q&A: How do I Know if I have the OEM Prep Package (Puck System) in the Bed of My Truck?
- Q&A: Are Spacers in 5th Wheel Installation Kit RP50082-58 Required for Installation
- Q&A: Recommended Replacement For A Marshall 605H LP Regulator
- Q&A: What Size Hole Saw do I Need to Make the Hole in the Bed of My Truck to Install B&W Gooseneck Hitch?
- Q&A: How to Flip a 2" Square Axle so the Axle is Below the Springs
- Article: How Much Weight Can I Put on My Trailer Hitch?
- Q&A: What is Meant by 16K Gross Towing Weight Rating on Curt 5th Wheel Hitch # C16115
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: Trailer Wiring Diagrams
- Article: How to Raise Your Travel Trailer Height