Hole Size for Curt Double Lock Flip/Store Gooseneck Hitch # C60721 on 2005 F-150 640 Series
Published 07/29/2015
Question:
2005 F150 4wd 6.5 foot bed. I purchased this kit and have not installed yet but, in reviewing the instructions for the sub kit C-641 theres a side not that says for c630/c640 use 3 5/8-inch hole saw all others use 4. I have a 640 series does that mean i use the 3 5/8? Thanks.
asked by: Andy
1
Helpful Expert Reply:
According to page 1 of the written instructions for the Curt Double Lock Flip and Store Underbed Gooseneck Hitch # C60721 your 640-series truck will require a 3-5/8-inch hole.
expert reply by:
Adam R
1
Product Page this Question was Asked From
Curt Double Lock, Flip and Store Underbed Gooseneck Hitch w/ Installation Kit - 30,000 lbs
- Gooseneck Hitch
- Below the Bed
- Flip-Over Ball
- 7500 lbs TW
- 30000 lbs GTW
- Wheel Well Release
- Spring-Loaded Loop
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Gooseneck Hitch
- Q&A: Correct Location for Gooseneck Hitch Ball Hole In a 2013 Ford F-150 Truck Bed
- Q&A: Gooseneck Hitch For A 2013 Ford F-150 With A 5-1/2 Foot Bed
- Q&A: How To Measure To Make Sure The MORryde CRE3000 Equalizers Will Fit Your Trailer
- Q&A: No Signal on Furrion Vision S Wireless RV Backup Camera System
- Q&A: Which Brake Controller Install Harness Fits 2022 Ford E-450 Cutaway
- Q&A: Replacement Option For Norcold N306.3 RV Fridge
- Q&A: Recommended Complete Replacement AC System for a Dometic Duo Therm
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Gooseneck to 5th Wheel Adapters
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps